為了使冷凝器在比較好的狀態下運行，就必須對冷凝器進行專門的化學藥物處理，清除水垢、銹蝕、粘泥、殺菌和防腐蝕處理，還原成清潔的金屬表面。
In order to make the condenser run in a better state, the condenser must be treated with special chemical drugs to remove the scale, rust, mud, germicidal and corrosion prevention treatment, so as to restore the clean metal surface.
冷凝器清洗操作流程：
Condenser cleaning operation process:
1、關閉進出水閥門，打開排污閥，檢查進出水閥關閉情況。
1, close the inlet and outlet valves, open the drain valve and check the closing of the inlet and outlet valves.
2、 打開冷凝器端蓋，在銅管表面取一點水垢，用除垢劑劑做不同濃度配比的除垢試驗。
2. Open the condenser end cover, take a little scale on the surface of the copper tube, and use scale remover to do the scale removal test with different concentration ratio.
3、 按低進高出方法，正確接好清洗泵。
3, according to the method of low in and out, correctly connect the cleaning pump.
4、利用外接水泵，往桶中注滿水，啟動清洗泵循環至水平穩。
4, use external pump, fill the water into the bucket, start cleaning pump to the level of stability.
5、 分次緩慢往桶中加YX-22除垢劑。循環后用自來水反復沖洗至 PH值 至7左右。
5, divide slowly into the bucket with YX-22 detergent. After recycling, rinse the tap water to pH value of 7.
6、用自來水沖洗清洗泵。
6. Rinse the pump with tap water.
7、 打開端蓋使用亞欣全自動通炮機進行通炮。
7. Open the end cover and use the Yaxin automatic gun gun.